ENG
32
The "Clear list" button deletes all entries.
Fig. 53
Message
function
(only for
control
panel)
The control panel can be used as a message centre, i.e. windows and doors can be monitored
using window contacts and rooms can be monitored by means of motion detectors.
If a window is broken open or if a motion detector detects a motion inside a room while the
message system is activated, a message is transmitted to the control panel which now triggers
the internal alarm. In addition, e.g. an external horn or a siren can be switched on.
At the same time, the message is displayed in the display (see also "List of alerts"). If required,
a message may also be transferred to a telephone interface which informs you or calls for
further help by phone.
If a window contact of a motion detector is faulty, this is indicated by a corresponding fault
message (see "List of alerts").
Activation and inactivation of the system can be directly on the control panel after entering a
PIN code or by corresponding bar-type switching contacts, block locks, keylock switches or PIN
code keypads, e.g. when leaving the house.
To Next Page
Loading...
