ABB Ability - Supplying Power and Product Startup

9
ABB ABILITY
TM
EDGE INDUSTRIAL GATEWAY
56
This product is not provided with any ON/OFF switch.
The Power IN connector is the disconnecting means from the power supply network.
—
9.1 How to supply power to the product
9.1.1 Power IN connector and mating connector specifications
The power input is protected against: surge, noise, reverse polarity, over-voltage.
NOTICE
The Power IN connector is NOT protected against short circuit. Always include an external
fuse to protect the product!
The ABB Ability™ Edge Industrial Gateway provides the Power IN connector on the rear side.
Connector layout:
Connector Pinout:
Connector specifications:
• Base strip, Header.
• Gender: Male.
• Type: 3-pin, 3.5 mm pitch.
Mating connector specifications:
• Pluggable screw terminal block.
• Gender: Female.
• Type: 3-pin, 3.5 mm pitch.
• Example:
• Manufacturer: Phoenix Contact.
• Part Number: MC 1,5/ 3-STF-3,5 - 1847068 (or equivalent).
—
How to supply power to the product
Power supply 
Power consumption 
Peak demand 
Pin # Signal Type Description
 V+ P 
 D- IO Negative data
 D+ IO Positive data
 GND P Ground