10
ABB ABILITY
TM
EDGE INDUSTRIAL GATEWAY
60
Periodically inspect the product to verify its integrity and to ensure proper operation. To maintain the
product, complete the following steps:
1. Carefully read and understand the instructions contained in the section “Safety Instructions” on
page 8.
2. Safely remove the power supply.
3. Verify the installation of the product.
4. Clean the product.
—
10.1 How to safely remove the power supply
WARNING!
ELECTRIC SHOCK HAZARD
Failure to remove power correctly may create an electric shock hazard, which could result in personal
injury or loss of life, and / or damage the equipment or other property.
To avoid injuries and safely remove power supply from the product, complete the following steps:
1. Make sure your hands are dry.
2. Turn OFF all the power supply sources.
3. Disconnect all the cables.
4. Make sure that all the circuits are discharged.
—
10.2 How to verify the installation of the product
To verify the installation of the product, complete the following steps:
1. Verify that the product is clean and not damaged.
2. Verify that the LED indicators are visible and not damaged.
3. Verify that all the locking parts (for example: screws, bolts, nuts) are correctly fastened.
4. Verify that the product is installed correctly.
—
10.3 How to clean the product
To clean the product, complete the following steps:
1. Never use detergents, aerosol sprays, solvents or abrasive sponges.
2. To remove dust from the case of the product, use a dry, lint-free, cloth.
3. To remove the dirt, use water-based, non-flammable, cleaner products.
—
How to maintain the product
To Next Page
Loading...
