ABB Ability - Attaching I;O Module to Gateway

ABB ABILITY
TM
EDGE INDUSTRIAL GATEWAY
87
14
14
—
14.2 How to install the product
14.2.1 How to attach I/O module to ABB Ability™ Edge Industrial Gateway
• Attach the I/O additional module 10-12-xx unit to the ABB Ability™ Edge Industrial Gateway as shown
below using M2.5 x 5 CAP Head screw.
• Screw the I/O additional module module mounting plate to the same flat surface as the ABB Ability™
Edge Industrial Gateway.
Which screws are used
The 4 screws are used to attach I/O module to ABB Ability™ Edge Industrial Gateway:
• M2.5 x 5 CAP Head Hexagon Socket.
• Black A4 Stainless steel, fully threaded.
—
Figure 35
—
Figure 36