Need help?Do you have a question about the ABB ACH 500 and is the answer not in the manual?
General| Output frequency | 0 ... 500 Hz |
|---|---|
| Degree of protection | IP20 |
| Mounting method | Wall |
| EMC filter | Built-in |
| Control Method | Scalar control, sensorless vector control |
| Protection Features | Overcurrent, overvoltage, undervoltage, overload, short circuit |
| Enclosure Rating | IP20 |
Guidelines for safe operation and warnings related to electrical hazards and equipment damage.
Explanation of graphical symbols used to denote hazards and precautions in the manual.
Describes the hierarchical structure of parameters and how to navigate them.
Details parameters for initial drive setup, including language and application macro selection.
Details how to view and modify individual parameter values.
Lists and explains parameters essential for initial drive and motor setup.
Explains how to access and set the Start-up Data parameters.
Describes each Start-up Data parameter and its available settings.
Explains how to monitor and select drive parameters for status and activity.
Details how to lock and unlock drive parameters to prevent unauthorized changes.
Lists typical parameter values for the HVAC application macro.
Lists typical parameter values for the HVAC-PI application macro.
Lists typical parameter values for the Pump and Fan application macro.
Details parameters for controlling start/stop and direction.
Explains parameters for start, stop, and direction control inputs.
Explains parameters for setting frequency and current limits.
Details parameters for start, stop, and braking functions.
Explains parameters for acceleration and deceleration ramp settings.
Covers parameters for motor control modes and settings.
Covers parameters for motor and drive protection.
Explains parameters for fault detection and response.
Details parameters for the PI controller, used in HVAC-PI macro.
Explains parameters for the Pump and Fan control macro.
Parameters for fault detection, reset, and supervision.
Parameters for configuring fault detection and response.
Parameters for the PI controller used in HVAC-PI macro.
Parameters for the Pump and Fan control macro.
To Next Page
