￭ Load profile
In the Load profile submenu, you can view and configure load profiles.
The menu contains the following sub-menus:
• Amplitude logger 1: Opens a Histogram view, which displays the motor current as a
distribution histogram. This logger cannot be reset.
• Amplitude logger 2: Opens a Histogram view, which displays the contents of an
amplitude logger as a distribution histogram. You can select the signal to be monitored.
• Load profile configuration: Select the signal to be monitored in Amplitude logger 2.
• Peak value logger: Select a signal to be monitored by a peak value logger.
For more information on load profiles, see the appropriate firmware manual.
Backups
In the Backups menu, you can save parameter settings in the control panel memory and
restore parameter settings from a backup to the drive. You can store up to two backup files
on the control panel.
The assistant panel has a dedicated space for one automatic backup. An automatic backup
is created two hours after the last parameter change. After completing the backup, the panel
44 Functions in the main Menu
To Next Page
Loading...
