ABB ACS-AP-W - Connecting control panel to PC USB

Connecting control panel to PC USB
Note: When connected to a PC, the control panel displays the USB screen and does not
respond to key presses. In this mode, you can only interact with the control panel or the
drive through the PC tool.
To connect the control panel to a PC,
1. Open the lid of the USB connector.
2. Plug in a USB cable.
3. Connect to a PC.
The control panel displays the USB screen.
The USB connector lid is attached to the panel through a loose rubber band. You can always
connect back the lid to the band, if it disconnects accidentally.
1
2
Rubber band
USB connected
72 Panel-to-PC USB connection