ABB ACS310 - Page 27

Actual signals and parameters in the short view 27
6. Actual signals and
parameters in the short view
Note: When the control panel is in the short parameter view, ie when parameter 1611
PARAMETER VIEW is set to 2 (SHORT VIEW), the control panel only shows a
subset of all signals and parameters. These signals and parameters are described in
this chapter.
To be able to view all actual signals and parameters, set parameter 1611
PARAMETER VIEW to 3 (LONG VIEW). For the description of all actual signals and
parameters, refer to chapter Actual signals and parameters in ACS310 Users
Manual (3AUA0000044201 [English]).
Terms and abbreviations
Fieldbus equivalent
Example: If 2008 MAXIMUM FREQ (see page 31) is set from an external control
system, an integer value of 1 corresponds to 0.1 Hz. All the read and sent values are
limited to 16 bits (-3276832767).
Term Definition
Actual signal Signal measured or calculated by the drive. Can be monitored by the user.
No user setting possible. Groups 0104 contain actual signals.
Def Parameter default value
Parameter A user-adjustable operation instruction of the drive. Groups 1099 contain
parameters.
Note: Parameter selections are shown on the Basic Control Panel as integer
values. Eg parameter 1001 EXT1 COMMANDS selection COMM is shown as
value 10 (which is equal to the fieldbus equivalent FbEq).
FbEq Fieldbus equivalent: The scaling between the value and the integer used in
serial communication.
E Refers to types 03E- with European parametrization
U Refers to types 03U- with US parametrization