ABB ACS880-01 - Materials of frames R1 to R3

10
13. Start-up the drive
WARNING! Obey these instructions. If you ignore them, injury or death, or damage to the equipment can occur. If
you are not a qualified electrical professional, do not do electrical installation or maintenance work.
Use the control panel to do the start-up procedure. The two commands at the bottom of the display show the functions of
the two softkeys and located below the display. The commands assigned to the softkeys are different
depending on the context. Use the arrow keys , , and to move the cursor or change values depending on the
active view. Key shows a context-sensitive help page.
1.
Power up the drive. Make sure that you
have the motor name plate data
available.
2.
The First start assistant guides you
through the first start-up.
Select Menu and press (Menu) to
open the main Menu.
Select Assistants and press
(Select).
3.
Select Basic setup and press
(Select).
4.
Select the language you want to use
and press (Next).
Note: After you have selected the
language, it takes a few minutes for
the control panel to wake up.
5.
Select the localization you want to use
and press (Next).
6.
Do the following selections. After each,
press (Next).
7. 8. 9.
10. 11. 12.
?