ABB AMB Series - Chapter 2 - Transport and Unpacking; 2.1 Protective measures prior to transport; 2.2 Lifting the machine; 2.4 Checks upon arrival and unpacking

Manual for Induction Motors and Generators
2 -
3BFP 000 050 R0101 REV E
3.3.6 Drain plugs.............................................................................................. 22
3.4 Installation on concrete foundation.......................................................................... 23
3.4.1 Scope of delivery..................................................................................... 23
3.4.2 General preparations ............................................................................... 23
3.4.3 Foundation preparations.......................................................................... 23
3.4.3.1 Foundation and grouting hole preparations...................... 23
3.4.3.2 Foundation studs or sole plate preparations ..................... 23
3.4.4 Erection of machines............................................................................... 25
3.4.5 Alignment................................................................................................ 25
3.4.6 Grouting .................................................................................................. 25
3.4.7 Final installation and inspection.............................................................. 25
3.4.7.1 Dowelling of the machine feet ......................................... 25
3.4.7.2 Covers and enclosures...................................................... 26
3.5 Installation on steel foundation................................................................................ 26
3.5.1 Scope of delivery..................................................................................... 26
3.5.2 Check of foundation................................................................................ 26
3.5.3 Erection of machines............................................................................... 26
3.5.4 Alignment................................................................................................ 26
3.5.5 Final installation and inspection.............................................................. 26
3.5.5.1 Doweling of the machine feet........................................... 26
3.5.5.2 Covers and enclosures...................................................... 27
3.5.6 Installation of flange mounted machines on steel foundation................. 27
3.6 Alignment................................................................................................................. 27
3.6.1 General.................................................................................................... 27
3.6.2 Rough levelling....................................................................................... 28
3.6.3 Rough adjustment.................................................................................... 28
3.6.4 Correction for thermal expansion............................................................ 30
3.6.4.1 General ............................................................................. 30
3.6.4.2 Thermal expansion upwards............................................. 30
3.6.4.3 Thermal axial growth ....................................................... 31
3.6.5 Final alignment........................................................................................ 31
3.6.5.1 General ............................................................................. 31
3.6.5.2 Run-out of the coupling halves ........................................ 31
3.6.5.3 Parallel, angular and axial alignment ............................... 32
3.6.5.4 Alignment......................................................................... 33
3.6.5.5 Permissible misalignment................................................. 34
3.7 Care after installation............................................................................................... 35
Chapter 4 - Mechanical and Electrical Connections
4.1 General..................................................................................................................... 36
4.2 Mechanical connections........................................................................................... 36
4.2.1 Cooling air connections........................................................................... 36
4.2.2 Cooling water connections...................................................................... 36
4.2.2.1 Air-to-water coolers.......................................................... 36
4.2.2.2 Water cooled frames......................................................... 36
4.2.3 Sleeve bearing oil supply ........................................................................ 37
4.2.4 Connection of purging air pipe ............................................................... 38
4.2.5 Mounting of vibration transducers.......................................................... 38
4.3 Electrical connections .............................................................................................. 38
4.3.1 General information ................................................................................ 38