What to do if the ABB AMXE160 Engine does not start, has no current, and makes no noise?
If the ABB Engine does not start, shows no current, and makes no noise, there is likely an interruption on at least two phases, indicating an open circuit. Measure the resistance between the phases to check for stator damage. If the stator is damaged, contact ABB for further instructions.
Why is the insulation resistance below 10 MΩ in the ABB Engine?
If the insulation resistance is below 10 MΩ in the ABB Engine, the stator winding is too damp. Check for any defect components such as covers or seals. The stator winding must be oven dried; please contact ABB for further instructions.
What causes high vibrations at run out in the ABB Engine?
If there are high vibrations at run out in the ABB Engine, it is likely due to too high residual unbalance. Please contact ABB for further instructions.
What causes the ABB Engine to start with abnormal permanent scraping noise?
If the ABB Engine starts with abnormal permanent scraping noise, it is because the rotor and stator touch each other in the air gap. Please contact ABB for further instructions.
What to do if the ABB Engine starts with a scraping noise?
If the ABB Engine starts with a scraping noise, it could be due to foreign particles in the air gap. Please contact ABB for further instructions.
Why is the ABB Engine vibrating and generating abnormal noise?
If the ABB Engine is vibrating and generating abnormal noise, it might be due to a damaged bearing. Please contact ABB for further instructions.
Why does the ABB AMXE160 get an abnormally high phase current and high temperature, even at no load?
If the ABB Engine gets an abnormally high phase current and high temperature, even at no load, it indicates a wrong incoming voltage level. Correct the incoming voltage levels.
What causes abnormally high current in an ABB AMXE160 Engine?
If the ABB Engine current is abnormally high, it may be caused by demagnetized rotor magnets. Operation can continue with reduced performance. Contact ABB to replace the rotor for full performance.
Why is the ABB AMXE160 Engine current abnormally high?
If the ABB Engine current is abnormally high, it could be due to a fault in the stator winding. Measure the winding resistance between the stator terminals.
Why is the ABB AMXE160 abnormally hot even at no load?
If the ABB Engine is abnormally hot even without any load, the liquid cooling system may not be working correctly. Check the functionality of the liquid cooling system.
To Next Page
General
