178 AO2000 CONTINUOUS GAS ANALYZERS | OI/AO2000-EN REV. B
Changing the unit
1 Press COMP. CONFIG. softkey. The "Configure Component" menu is
displayed with the component list.
2 In the component list select the component with unit which is to be
changed.
3 Press UNIT SELECTION softkey. Enter password (level 3), as applicable.
A list of the units available is displayed.
4 Select the desired unit and confirm with ENTER.
5 A security prompt appears with the information that when switching
the unit, the range limits of the component are automatically adjusted.
6 Confirm the switching of the unit with ENTER or cancel with Back.
7 Quit the menu with Back or Meas.
8 Check the range limits (see page 156) and the number of decimal places
(see page 158) and adjust if necessary.
To Next Page
Loading...
Need help?
General
