What to do if ABB Measuring Instruments show 'MEASURING RANGE EXCEEDED'?
If the ABB Measuring Instruments display 'MEASURING RANGE EXCEEDED', it means the current measurement is beyond the instrument's capacity. To resolve this, choose another type of reagent within the Basic program settings.
What to do if ABB AW101 Measuring Instruments show 'REAGENT LOW'?
If the ABB Measuring Instruments indicates 'REAGENT LOW', it means the reagent level is below the minimum threshold: 50 ml (10%) without BOB, or a calculated value with BOB. To fix this, check the reagent level and refill if necessary. Then, enter the new level in the system by navigating to M ? SERVICE.
Why is there low water pressure in my ABB Measuring Instruments?
Low water pressure in your ABB Measuring Instruments can occur due to several reasons: no water input even when LED I is lit, inlet pressure being too low, overflow reagent not being active, or an oxidized connector on the inlet valve. Resolve this by checking the water inlet, cleaning the filter strainer, replacing the valve block, extracting the pressure regulator valve, or carrying out an adjustment.
What to do if ABB AW101 show 'Ff. DOSING FAULT'?
If the ABB Measuring Instruments display 'Ff. DOSING FAULT', it indicates a dosing inaccuracy with the dosing pump. Correct this by replacing the dosing pump or returning it to the supplier for calibration.
What to do if ABB AW101 show 'Ff. OUTLET TO DRAIN'?
If the ABB Measuring Instruments displays 'Ff. OUTLET TO DRAIN', it means water remains in the measuring chamber even when the LED OUT is lit. To address this, check the water outlet and replace the valve block if the connector of the outlet valve is oxidized.
What to do if ABB Measuring Instruments show 'Mf. ANALYSIS' error?
If the ABB Measuring Instruments displays 'Mf. ANALYSIS' error, it may be due to an incorrect analysis caused by issues such as air in the dosing capillary, incomplete blending, or using old or third-party reagents. To resolve this, tighten the connections of the dosing pump, replace the stirring mechanism, replace the suction insert in the bottle, and use only ABB reagent.
How to fix 'Ff. DOSING PUMP' error in ABB Measuring Instruments?
To fix the 'Ff. DOSING PUMP' error in ABB Measuring Instruments, check the cable connection to the dosing pump to ensure it is correct. If the dosing pump is defective, replace it.
What to do if ABB AW101 Measuring Instruments show 'Ff. OPTICS' error?
If the ABB Measuring Instruments displays 'Ff. OPTICS' error, it could be due to a defective plug-in circuit board or an issue with the optic component (transmitter or receiver). To resolve this, replace the plug-in circuit board or replace the measuring chamber sealing rings.
What causes 'Mf. TURBID' error in ABB AW101?
The 'Mf. TURBID' error in ABB Measuring Instruments indicates that the water being measured is turbid or dirty. No direct solution.
How to resolve 'Mf. DIRTINESS' issue in ABB AW101?
The 'Mf. DIRTINESS' issue in ABB Measuring Instruments occurs when the sight-glass windows are dirty. To resolve this, clean the sight-glass windows.
General| Brand | ABB |
|---|---|
| Model | AW101 |
| Category | Measuring Instruments |
| Language | English |
To Next Page