ABB AW101 - Basic Program; Program Values; Structure of the Basic Programming

Water Hardness Analyzer
AW101 Testomat 5Menu Structure
IM/AW101 Rev. C 13
5.7 Basic Program
After the menu has been accessed with ENTER, carry out the
BASIC PROGRAMMING of the unit.
5.8 Program Values
To call up the factory-set basic default setting, hold down the M
and i keys briefly while switching the unit ON.
Values and settings are described in the structure of the basic
program.
5.8.1 Structure of the Basic Programming
Abbreviations: s = seconds m = minutes, h = hours, d = days, l
= liters
Fig. 5.4 Basic Programming Structure
Caution. To reset the factory-set basic default setting, hold down the M and i keys briefly while switching the unit ON.
The previous configuration is erased.
Volume interval
TIME CONTROLLED*
TYPE TH2005
TIME 10m
LV1:025 dH
FLUSH 10s
DISPLAY dH *
1 L/IMPULSE
FUNCTION ON
DURATION *
DURATION *
HYSTERESIS LV2 1
HYSTERESIS LV2 1
TYPE 0-20 mA
NORM.OPEN.CONT.
TYPE TH2025 *
TYPE TH2100
TYPE TH2250
°
LV2:035 dH
°
Function off *
Impulse
Interval
Time 00m:10s
Type 4-20 mA *
Volume 0001
°
Display f
°
Display ppm CaC03
Display mmo1/1
2.5 l/Impulse
5 l/Impulse
10 l/Impulse
100 l/Impulse *
500 l/Impulse
1000 l/Impulse
Imp./l xxx.x
Impulse
Interval
Two point
Time 00m:10s
Norm.close con *
ENTER
ENTER
PROGRAM MENU
Testomat ECO
BASIC PROGRAM
PROGRAM VALUES
MODE OF OPERAT.
Interval
Type of reagent
Display of unit
Limit values
Flush time
Water meter
BOB operation
Function LV1
Function LV2
Hysteresis LV1
Hysteresis LV2
Function Stop
Interface