ABB AquaProbe FEA200 User Guide

User Guide OI/FEA100/200–EN Rev. C
AquaProbe FEA100 / FEA200
Electromagnetic flowmeter
Insertion-type flow sensors
Maximum performance,
minimum hassle
Introduction
The AquaProbe FEA100 / FEA200 flow sensor is
designed for measurement of the velocity of water. The
flow sensor is available in four standard lengths and can
be installed in any pipeline of internal diameter from 200
mm (8 in.) to 8000 mm (360 in.), through a small
tapping.
The flow sensor is designed for use in survey
applications such as leakage monitoring and network
analysis and in permanent locations where cost or space
limitations preclude the use of conventional closed pipe
meters.
This User Guide provides installation, connection,
security, start-up and basic setup details for the flow
sensor only. The AquaProbe sensor is available for
operation with either a WaterMaster transmitter (FET100)
or an AquaMaster3 transmitter (FET200).
This User Guide should be used in conjunction with the
following publications:
WaterMaster flowmeter (FEA100):
– User Guide – OI/FET100-EN
– Programming Guide – IM/WMP
– User Guide Supplement, PROFIBUS RS485 Physical
Layer (FEX100-DP) – IM/WMPBS–EN
– User Guide Supplement, PROFIBUS FEX100-DP
Parameter Tables – IM/WMPBST–EN
AquaMaster flowmeter (FEA200):
– User Guide – OI/FET200-EN
– Programming Guide COI/FET2XX-EN
– MODBUS Tables Supplement –
COI/FET2XX/MOD/TBL-EN
ScrewDriver profiling and Configuration software:
–User Guide – OI/SDR

ABB AquaProbe FEA200 Specifications

General

Brand	ABB
Model	AquaProbe FEA200
Category	Security Sensors
Language	English