2CMC486004M0201 25 C13
Revision: A User Manual
Meter Settings
Read alarm
The Output option in the View menu shows whether a programmed alarm has
been triggered or not. A triggered alarm displays as AL On, and an alarm that has
not been triggered displays as AL OFF.
5 Set the time frame that the measured value
must pass the set alarm value in order for the
alarm to trigger (Alarm on delay).
Use the short press to change
the value of the digit, and the
long press to step through the
different digits.
6 Set the alarm value that the measured value
must pass in order for the alarm to be cleared
(Alarm level off).
Use the short press to change
the value of the digit, and the
long press to step through the
different digits.
7 Set the time frame that the measured value
must pass the set alarm value in order for the
alarm to be cleared (Alarm off delay).
Use the short press to change
the value of the digit, and the
long press to step through the
different digits.
8 To save the alarm settings and enable the
alarm function, use the long press when lo-
cated in the save-menu ( on the display).
After performing this setting, the alarm is set.
If not choosing the option
save, the settings will not be
saved and the previously
saved setting will be used in-
stead. The alarm will not be ac-
tivated.
Step Action Comment
To Next Page
Loading...
Need help?
General
