ABB C1900 Series User Guide

11
7.1 Basic Configuration Level – Fig. 7.1
The general content of the Basic Configuration Level is detailed in IM/C1900-PGC, Section 3 .
Any changes or additions to Basic Configuration Level frames are detailed in this Sections 7.1.1 to 7.1.11 of this manual.
An additional (Divert) page is also included in this level as shown in Fig. 7.1.
7 BASIC CONFIGURATION LEVEL
Note. Refer to Section 7.1.10 on page 15 for access to
Pen Adjust frame in Operator Level.
† Displayed on models 1952 and 1953 only
Fig. 7.1 Basic Configuration Level
SEtUP
INPUt
Set Up Input
SEtUP
ALArMS
Set Up Alarms
Set Up Inputs
IM/C1900-PGC
Section 3.1 Page 4
Set Up Pen Range
IM/C1900-PGC
Section 3.2 Page 8
Set Up Alarms
IM/C1900-PGC
Section 3.4 Page 10
Set Up Chart
IM/C1900-PGC
Section 3.3 Page 9
SEtUP
PENrNG
Set Up Pen Range Set Up Chart
SEtUP
CHArt
Set Up Relay Output
IM/C1900-PGC
Section 3.5 Page15
Set Up Output
SEtUP
rELAYS
OPrtOr
LEVEL
bASIC
CONFIG
CONtrOL
CONFIG
Basic Config.
Control Config.
Operator Level
AdVNCd
CONFIG
Advanced Config.
SEtUP
dIVErt
Page Header
RT Deviation Trip
Secondary Div. Src.
t-HYSt
HYSt-1
d-_OdE
Divert Mode
rt-dEV
2d-SrC
dVrt-1
Divert Number
dIVErt
2nd RTD Value
2nd rt
Divert Set Point 1
Divert Hyst. Point
Time Hysteresis
Panel 2 Setup
PANL-2
Divert Page
Section 7.1.5
Page 13
F.d-COL
Set Forward Color
SrCE-1
Set Point Source 1
HOt-1
Hot Temp. 1
SrCE-2
Set Point Source 2
HOt-2
Hot Temp. 2
Divert Set Point 2
dVrt 2
SrCE-8
Set Point Source 8
HOt-8
Hot Temp 8
Divert Set Point 8
dVrt 8
1951 Only
1952/3
Single
Multi
Multi
LK-Src
CIP.Src
Cleaning In place
Leak Condition Source
†
†
†
†
Single RT
Single
2nd RTD Enable
2nd rt
rt-dVt
Enable operator level
divert no. selection
OP LEV
Enable rt divert
See Note

ABB C1900 Series Specifications

General

Brand	ABB
Model	C1900 Series
Category	Measuring Instruments
Language	English