ABB FlexPendant - Repair and Replacement; Replacing the Brake Mechanism

4 Repair
4.1 Replacing the brake
Introduction
The brake limits the rolling speed when retracting the cable. The brake loses power
gradually over time and should be replaced.
CAUTION
If the brake is not working, then the FlexPendant can be damaged if the retraction
is so strong that the operator loses his grip.
xx1300002383
Replacing the brake
Use this procedure to replace the brake on the FlexPendant Retractable Cable.
NoteAction
Retract the cable so that all cable is inside the
housing.
1
Continues on next page
Product manual - FlexPendant Retractable Cable 37
3HAC048816-001 Revision: B
© Copyright 2015-2016 ABB. All rights reserved.
4 Repair
4.1 Replacing the brake