24
The spring is now loaded.
d) Remove the operating lever.
e) Push pushbutton downwards to release pushbuttons
(arrow).
2. Switch-disconnector opening from “closed” position
a) Push pushbutton to the left (green “O”) to set unit to the
“open” position.
Fig. 36 - “Open” position
Fig. 40 - “Closed” position
Fig. 41 - “Open” position
Fig. 37 - “Closed” position
Fig. 39 - “Closed” position
Fig. 38 - “Open” position
f) Push pushbutton to the right (green “I”) to set unit to the
“closed” position.
The spring is now loaded.
d) Remove the operating lever.
e) Push pushbutton downwards to release pushbuttons
(arrow).
To Next Page
Loading...
