Operation Manual / 4 Product description / TPS44-H.. - TPS52-H..
3 Commissioning / 3.2 Inspection procedures
© Copyright 2017 ABB. All rights reserved. HZTL4037_EN Revision E July 2017
3.2 Inspection procedures
3.2.1 Introduction
Inspection procedures include preventative visual controls, monitoring and measuring work
before and during commissioning. Inspection procedures enable changes to the turbochar-
ger to be detected. Engine damage can be prevented.
3.2.2 Checks before commissioning
Filter mat (if available)
u Check for damage and contamination.
Lubricating system
CAUTION
Contaminated oil
Serious damage to engine or property can be caused by dirt and solid ma-
terial particles in the oil.
u For the initial commissioning phase and after all service work, flush the
complete lubricating system with warm oil.
u Use special running-in filters when running in the engine and after all ser-
vice work on the lubricating system.
u Check that the oil filter is clean before commissioning.
u Adhere to lubricating oil pressure at the inlet.
u Adhere to lubricating oil temperature at the inlet.
u For permissible values, see chapter Monitoring operation →17.
Warning plates
u Check whether warning plates are present and legible.
u Check whether the protective sheets have been removed.
Page 14 / 77
To Next Page
Loading...