ABB Relion 670 series - Manual Configuration of Central Account Management

Transformer input module TRM
M14875-3 v10
The transformer input module is used to galvanically
separate and adapt the secondary currents and voltages
generated by the measuring transformers. The module
has twelve inputs in different combinations of currents
and voltage inputs.
Ring lug or compression type connectors can be
ordered.
High impedance resistor unit
M16727-3 v2
The high impedance resistor unit, with resistors for
pick-up value setting and a voltage dependent resistor,
is available in a single phase unit and a three phase unit.
Both are mounted on a 1/1 19 inch apparatus plate with
compression type terminals.
Layout and dimensions
IP14539-1 v1
Dimensions
IP14826-1 v1M15243-4 v7
IEC08000163‐3‐en.vsdx
IEC08000163 V3 EN-US
Figure 19. Case with rear cover
IEC08000165‐3‐en.vsdx
IEC08000165 V3 EN-US
Figure 20. Case with rear cover and 19” rack mounting kit
IEC06000182-2-en.vsd
IEC06000182 V2 EN-US
Figure 21. A 1/2 x 19” size IED side-by-side with RHGS6.
M15243-12 v11
Table 11. Case dimensions
Case size
(mm)/
(inches)
A B C D E F G H I
6U, 1/2 x 19” 265.9/
10.47
223.7/
8.81
247.5/
9.74
255.0/
10.04
205.8/
8.10
190.5/
7.50
466.5/
18.36
232.5/
9.15
482.6/
19
6U, 3/4 x 19” 265.9/
10.47
335.9/
13.23
247.5/
9.74
255.0/
10.04
318.0/
12.52
190.5/
7.50
466.5/
18.36
232.5/
9.15
482.6/
19
6U, 1/1 x 19” 265.9/
10.47
448.0/
17.65
247.5/
9.74
255.0/
10.04
430.1/
16.86
190.5/
7.50
466.5/
18.36
232.5/
9.15
482.6/
19
Line differential protection RED670
1MRK 505 379-BEN N
Version 2.2
Hitachi Power Grids 59
© Copyright 2017 Hitachi Power Grids. All rights reserved