What to do if ABB Industrial Equipment shows 'Time synch Fail Real time clock Ready'?
If the ABB Industrial Equipment indicates 'Time synch Fail Real time clock Ready' it means there's no time synchronization, though no specific problem has been detected. You should check the synchronization source for any issues. If the problem continues, it is recommended to contact your ABB representative for service.
Why does my ABB Measuring Instruments show 'Time synch Fail Real time clock Ready'?
If your ABB Measuring Instruments indicates 'Time synch Fail Real time clock Ready' it means that there is no time synchronization, but no problem has been detected. You should check the synchronization source for problems.
What does 'Internal fail On' mean on my ABB Measuring Instruments?
If your ABB Measuring Instruments displays 'Internal fail On', a failure has occurred. Check the rest of the indicated results to find the fault.
What does 'Internal warning On' mean on my ABB Measuring Instruments?
If your ABB Measuring Instruments displays 'Internal warning On', a warning has been issued. Check the rest of the indicated results to find the fault.
Why is Internal warning On showing on my ABB Controller?
If there is an internal warning on your ABB Controller, a warning has been issued. Check the rest of the indicated results to find the fault.
How to solve Time synch Fail Real time clock Ready on ABB Controller?
If there is no time synchronization, but no problem has been detected on your ABB Controller, check the synchronization source for problems. If the problem persists, contact your Hitachi Power grids representative for service.
What to do if ADC-module fails in ABB Measuring Instruments?
If the AD conversion module has failed in your ABB Measuring Instruments, contact your ABB representative for service.
What does internal warning on mean for ABB Measuring Instruments?
If the internal warning is on for ABB Measuring Instruments, it means a warning has been issued. Check the rest of the indicated results to find the fault.
What to do if ABB Control Unit shows Security Event 3810 CAM Server communication failed?
If the ABB Control Unit shows a Security Event 3810 indicating CAM Server communication failure, it means the server(s) are not reachable. Check if the LDAP server is up and running and check the IED connection.
Why is the ABB Control Unit showing a Diagnostics Replication Failed error?
If the ABB Control Unit displays a Diagnostics Replication Failed error, it can be due to the server(s) not being reachable or the server configuration having changed. Verify that the LDAP server is up and running. Verify with the system administrator that LDAP settings are still valid. Check the IED connection.
General| Product Type | Protection Relay |
|---|---|
| Manufacturer | ABB |
| Current Input | 1A / 5A |
| Communication Protocols | IEC 61850, IEC 60870-5-103, DNP3, Modbus |
| Display | LCD |
| Protection Functions | Overcurrent, Differential, Distance |
To Next Page