ABB Relion REM601 - Menu - Measurement

1MDU07212-YN Rev. D Section 5
Use of LHMI
REF601 / REJ601 / REM601 49
Application Manual
5.2.3 Menu – Measurement
Submenu Measurement shows analogue input values as primary or as secondary
values according to primary and secondary current of current transformer selected
in the submenu configuration – settings. Also it shows binary input and output
status at the relay terminal.
Figure 16: Measurement menu of relay REF601/REJ601/REM601
Measurements Primary Current I1:
XXXXX.XX A
Secondry Current
I2:
XXXXX.XX A
I3:
XXXXX.XX A
I0:
XXXXX.XX A
:
XXX %
I.2:
XXXXX.XX %In
t motor start:
XXX.X s
Istr max:
XXXX.X A
RStr Enable t:
XXX.X min
*
*
*
*
*
I1:XX.XX A
I2:XX.XX A
I3:XX.XX A
I0:XX.XX A
BI 1234
Status 0000
BO 123456
Status 000100
BI Status
0 – Low
1 – High
0 – Open
1 – Close
BO Status
Counter
Count :XXXXX
OPTS
RunTime:XXXXXhrs
*
Note * – only available when respective function in IED configuration