ABB RER620 - Station interrogation; Clock synchronization; Command transmission

Section 3 1MAC302441-MB A
IEC 60870-5-101/104 protocol implementation
48 RER620
Point List Manual
Station interrogation
(station-specific parameter, mark “X” if function is only used in the standard direction,
“R” if only used in the reverse direction, and “B” if used in both directions)
Information object addresses assigned to each group must be show in a separate table
Clock synchronization
(station-specific parameter, mark “X” if function is only used in the standard direction,
“R” if only used in the reverse direction, and “B” if used in both directions)
Command transmission
(object-specific parameter, mark with an “X” if function is used only in the standard
direction, “R” if used only in the reverse direction, and “B” if used in both directions)
X
global
X
group 1
X
group 7
X
group 13
X
group 2
X
group 8
X
group 14
X
group 3
X
group 9
X
group 15
X
group 4
X
group 10
X
group 16
X
group 5
X
group 11
X
group 6
X
group 12
X
Clock synchronization
X
Day of week used
RES1, GEN (time tag substituted/ not substituted) used
X
SU-bit (summertime) used
X
Direct command transmission
X
Select and execute command
Direct set point command transmission Select and execute set point command
X
C_SE_ACTTERM used
X
No additional definition
X
Short pulse duration (duration determined by a system parameter in the outstation)
X
Long pulse duration (duration determined by a system parameter in the outstation)
X
Persistent output