ABB RER620 - Test procedure

1MAC302441-MB A Section 3
IEC 60870-5-101/104 protocol implementation
RER620 49
Point List Manual
Transmission of Integrated totals
(station-specific parameter, mark “X” if function is only used in the standard direction,
“R” if only used in the reverse direction, and “B” if used in both directions)
Parameter loading
(station-specific parameter, mark “X” if function is only used in the standard direction,
“R” if only used in the reverse direction, and “B” if used in both directions)
Parameter activation
(station-specific parameter, mark “X” if function is only used in the standard direction,
“R” if only used in the reverse direction, and “B” if used in both directions)
Test procedure
(station-specific parameter, mark “X” if function is only used in the standard direction,
“R” if only used in the reverse direction, and “B” if used in both directions)
Mode A: Local freeze with spontaneous
Mode B: Local freeze with counter
X
Mode C Freeze and transmit by counter interrogation
X
Mode C Freeze by counter-interrogation command, frozen values reported
X
Counter read
X
Counter freeze without reset
X
Counter reset
X
General request counter
X
Request counter group 1
X
Request counter group 2
X
Request counter group 3
X
Request counter group 4
Threshold value
Smoothing factor
Low limit for transmission of measured value
High limit for transmission of measured value
Act/deact of persistent cyclic or periodic transmission of the addressed object
Test procedure