ABB S800 I/O - Page 116

*HQHUDO,QIRUPDWLRQDQG,QVWDOODWLRQ8VHU¶V*XLGH
$SSHQGL[$ 5HIHUHQFHV
106 3BSE 020 923R101
Signal voltage output (in parallel with DCOK LED) is derived from the output terminal voltage, but
the device signal status is independent of external voltage injection from power supply units
connected in parallel.
The output voltage is adjustable within the range 22.5 Volts to 28.5 Volts, and is factory set at 24
Volts ±1%.
Primary voltage setting needs no selection or adjustment, the full voltage range specified is covered
by the design.
The modules can be mounted on a standard DIN rail. It has a mechanical latch that locks it to the
DIN rail. The latch can be released with a screwdriver.
7HFKQLFDO'DWD
7DEOH $ 6'6'3RZHU6XSSO\0RGXOH 6SHFLILFDWLRQV
,WHP 6 '9DOXH 6'9DOXH
Output 24V d.c. @ 2.5A 24V d.c. @ 5.0A
Mains input voltage 110 - 240V a.c.
185 - 250V d.c.
110 - 240V a.c.
185 - 250V d.c.
Mains frequency
a.c.
d.c.
45 - 65 Hz
0 Hz
45 - 65 Hz
0 Hz
Rated input power, a.c.
Power factor
104 VA
0.67 typical
207 VA
0.67 typical
Rated input power, d.c. 70 Watts 140 Watts
Rated output power (at
24V)
60 Watts 120 Watts
Efficiency (50 - 100%
loading)
0.85 0.85
Power dissipation (full load) 11 W 22 W
Over-voltage protection 35V d.c. 35V d.c.