17
Second setting of
SGF2 checksum
Second setting of
SGR2 checksum
Event (n-3)
value of phase L1
Event (n-4)
value of phase L1
Event (n-3)
value of phase L2
Event (n-4)
value of phase L2
Event (n-3)
value of phase L3
Event (n-4)
value of phase L3
Duration of event (n-3)
starting of stage I>
Duration of event (n-4)
starting of stage I>
Duration of event (n-3)
starting of stage I>>
Duration of event (n-4)
starting of stage I>>
Event (n-3)
value of current Io
Event (n-4)
value of current Io
Duration of event (n-3)
starting of stage Io>
Duration of event (n-4)
starting of stage Io>
Duration of event (n-4)
starting of stage Io>>
Password for
altering settings
3
4
4
4
4
4
3
3
3
3
3
3
3
3
3
4
4
4
4
4
3
Number of low-set I>
starts since latest reset
Number of high-set I>>
starts since latest reset
Number of low-set earth-
fault starts since latest reset
Number of high-set earth-
fault starts since latest reset
Duration of event (n-3)
starting of stage Io>>
5
5
5
5
Main setting of
SGR3 checksum
Second setting of
SGR3 checksum
5
6
1
2
3
5
6
7
8
9
A
Second setting of
SGF1 checksum
Second setting of
SGR1 checksum
Selection of main vs.
second setting
4
Operating time for the
CB-failure protection
5
The procedures for entering a submenu or a
setting mode and the method of performing the
settings and the use of the TEST mode are
described in detail in the manual "General char-
acteristics of D type relay modules". A short
form guide to the operations is shown below.
Desired step or setting operation Push-button Action
Forward step in main menu or submenu STEP Push for more than 0.5 s
Rapid scan forward in main menu STEP Keep pushing
Reverse step in main menu or submenu STEP Push less than about 0.5 s
Entering submenu from main menu PROGRAM Push for 1 s
(Active on release)
Entering or leaving setting mode PROGRAM Push for 5 s
Increasing value in setting mode STEP
Moving the cursor in setting mode PROGRAM Push for about 1 s
Storing a value in setting mode STEP&PROGRAM Push simultaneously
Erasing of memorized values and STEP&PROGRAM
resetting of latched output relays
Resetting of latched output relays PROGRAM Note! Display must be off
Note! All parameters which can be set in the setting mode are indicated with the symbol .
To Next Page
Loading...
