TEIP11, TEIP11-PS | 42/18-46-EN Rev. L 11
6.1.3 Aluminum/stainless steel field mount housing
The sturdy housing unit can be installed outdoors without
protection.
Fig. 6: Aluminum/stainless steel field mount housing
1 Terminal for signal input (covered)
2 Cable entry 3 Supply air connection 4 Output (covered)
Installation instructions
Position the housing so that the cable gland is facing
downwards or sideways, to prevent humidity from penetrating
the device.
Accessories
A stainless steel mounting bracket is available as an accessory
for installation.
The mounting bracket is available in two designs:
— For wall mounting only.
— Universal for wall or 2" pipe mounting.
6.1.4 Field mount housing as a mounting module for
OEM applications (TEIP11)
Fig. 7: Aluminum/stainless steel field mount housing
1 Terminal for signal input (covered)
2 Cable entry 3 Supply air connection 4 Output (covered)
Installation instructions
Position the housing so that the cable gland is facing
downwards or sideways, to prevent humidity from penetrating
the device.
Accessories
A stainless steel mounting bracket is available as an accessory
for installation.
The mounting bracket is available in two designs:
— For wall mounting only.
— Universal for wall or 2" pipe mounting.
6.1.5 Plastic field mount housing
The plastic housing is suitable for installation on-site.
Fig. 8: Plastic field mount housing
1 Output (covered) 2 Supply air connection
3 Combustible gas discharge line, crimp connection, 6 mm
(0.24 inch) 4 Cable entry 5 Terminal for signal input (covered)
Installation instructions
Units can be mounted on walls or vertically on a 2" pipe.
The connections for the input and output signals should face
downwards, to prevent humidity from penetrating the device.
To Next Page
Loading...
