Need help?Do you have a question about the ABB DCS 500 and is the answer not in the manual?
Explains system's operational functions, block diagram, and power section.
Lists and explains error codes F65 and F66 and their triggers.
Visual representation of the 12-pulse logic and its signals within the DCS 500.
Explains master/slave division, parameter/signal groups, and independent operation.
Details parameter group 12, including OPER_SYS for mode selection.
Details new parameter group 36 for 12-pulse mode, e.g., REV_DELAY.
Details parameters and signals for the DCS 500 12-pulse power converter.
Details specific signals for 12-pulse mode like CONV_CUR_SLA, ARM_CUR_SLA, etc.
Contains start-up procedure and setting values for 12-pulse mode parameters.
Steps for starting up the 12-pulse configuration after installation.
Procedures for starting the master unit as a 6-pulse converter.
Procedures for starting the slave unit as a 6-pulse converter.
Key settings for 12-pulse mode, current limits, regulator optimization, and error checks.
Specific parameter settings for the master unit in 12-pulse mode.
Specific parameter settings for the slave unit in 12-pulse mode.
General| Brand | ABB |
|---|---|
| Model | DCS 500 |
| Category | Media Converter |
| Language | English |
To Next Page