ABB DCS 500 - REV_ERROR and CUR_ERROR Signals; INH_OUT Signal (13616)

Chapter 5 - Parameters and Signals
DCS 500 12-Pulse Planning and Start-Up 5 - 5
REV_ERROR
- Signal triggering Error 65
13614 P:U2 SC:
BOOLEAN
read only
CUR_ERROR
- Signal triggering Error 66
13615 P:U2 SC:
BOOLEAN
read only
INH_OUT
- Output signal from the switch-off logic
- Can be connected to the drive logic with (908), so that the units will switch each other off
in the event of an error
13616 P: U2 SC:
BOOLEAN
read only
X18_13
- Signal from Plug Connector X18:13
- operative in all modes
13617 P:U2 SC:
BOOLEAN
read only
X18_14
- Signal from Plug Connector X18:14
- Operative in all modes
13618 P:U2 SC:
BOOLEAN
read only
X18_15
- Signal from Plug Connector X18:15
- Operative in all modes
13619 P:U2 SC:
BOOLEAN
read only
X18_16
- Signal from Plug Connector X18:16
- Operative in all modes
13620 P:U2 SC:
BOOLEAN
read only