129
Figure 205:
Figure 208:
—
10. Product quality and environmental
protection
The UniGear panels are produced in compliance
with the requirements of international standards
for the quality management system and
environmental management system. In these
fields, the level of excellence achieved is
documented by quality certificates according to
ISO 9001 and by the EMS according to ISO 14 001.
End of life of product
ABB is committed to complying with the relevant
legal and other requirements for environmental
protection according to the ISO 14 001 standard.
Raw material
Recommended method of disposal
Metal material (Fe, Cu, Al, Ag, Zn, W, others)
Separatioin and recycling
Thermoplast Recycling or disposal
Epoxy resin Separation of metal and the disposal of rest
Rubber Disposal
Oil as dielectric (transformer oil)
Draining for equipment and further recyclilng or
disposal
SF6 gas
Discharging from equipment and further recycling
or disiposal
Packing material - wood Recycling or disposal
Packing material - foil Recycling or disposal
The duty of company is to facilitate subsequent
recycling or disposal at the end of product life.
During disposal of the product, it is always
necessary to act in accordance with local legal
requirements in force.
The following methods of disposal are possible:
Disposal can either be carried out thermally in an
incineration plant or by storing on a waste site.
To Next Page
Loading...
