Abbott IonicRF - Step 3: Attach the Generator to the Pole Mount

Step 3: Aach the Generator to the Pole
Mount
NOTE: Aaching the generator requires two people—one to hold the
generator in posion and one to aach the generator.
1.
Person 1: Lock the wheels on the roll stand.
1.
2.
Person 1: Ensure that the pole mount is fastened securely to
2.
the pole.
Figure 6. Aligning the screw holes with the capve thumb screws
1.
Generator
2.
Pole mount
3.
Pole
4.
Screw holes
5.
Capve thumb screws
3.
Person 1: Hold the generator in place.
3.
Person 2: Align the four screw holes on the back of the
generator with the capve thumb screws on the pole mount.
7