PN2 - There is no specific orientation for pins
1 and 2. Insert the two-threads hardware reset connector into the correct pins
of connector PN2 on the mainboard.
Pin number
Name of the signal or signification
1 Ground
2 Hardware Reset Signal
PN2 - There is no specific
orientation for pin 4 to pin 7. Connect the four-threads speaker cable to the
correct pins of connector PN2 on the mainboard.
Pin number
Name of the signal or signification
4 +5VDC
5 Ground
6 Ground
7 Sound Signal
PN2 - There is not specific
orientation for pins 9 and 10. Connect the two-threads connector to the
correct pins of connector PN2 on the mainboard.
Pin number
Name of the signal or signification
9 Anode terminal of Turbo LED
10 Cathode terminal of Turbo LED
H/W Reset connector:
Installing speaker connector:
Installing Turbo LED connector:
To Next Page
Loading...
