EN 15 EC-declaration
EC DECLARATION OF CONFORMITY
Council Directive 73/23/EC, supplement II, under A
Manufacturer ABK InnoVent
Adress Plakhorstweg 12
7008 AT DOETINCHEM
Hereby declares that the extractor:
- is in conformity with all relevant provisions of Council Directive 73/23/EC,
according to most recent version.
- is in conformity with all relevant provisions of Council Directive
89/336/EC, according to most recent version.
-is in conformity with the following harmonised standards:
NEN-EN-IEC 61591 Household range hoods
NEN-EN-IEC 60335 Household and similar electrical appliances-Safety.
Doetinchem, March 1st 2007
B. Kruse, Managing Director
EN 14 Maintenance
Brushed stainless steel
5.5 Maintenance of stainless steel
Clean with a soft/damp cloth and a minor
In the every day use, stainless steel
quantity of a liquid abrasive (like CIF).
surfaces are being damaged and polluted.
Move the cloth in the same direction as
These pollutions or damages can diminish
the polishing direction of the material.
the resistance against corrosion or even
cause corrosion, depending on the nature
Spray the surface with a stainless steel
of the pollution. Pollution and damages are
cleaner, rub in and wait several minutes
not only bad to the corrosion sustainability
and polish with a soft, dry cloth. This last
of the material, it will also have an effect
treatment gives the stainless steel a thin
on the appearance of the material. Greasy
protecting coating.
fingers, light deposits, scratches etc,
cause an neglected appearance.
Orbital grinded stainless steel
Therefore, it is necessary that the
stainless steel is given regular
Clean with a soft/damp cloth and a minor
maintenance.
quantity of a liquid abrasive. Move the
cloth in a random rotating direction.
The stainless steel requires specific ways
of maintenance and is based on the three
Spray the surface with a stainless steel
different finishes, i.e. brushed, orbital
cleaner, rub in and wait several minutes
grinded and glass bead blasted.
and polish with a soft, dry cloth. This last
treatment gives the stainless steel a thin
In case of a strong pollution and damages
protecting coating.
a change of the surface structure can exist
by cleaning. We therefore recommend to
Glass bead blasted stainless steel
only have a specialist taken care of these
kind of problems. Light pollutions (greasy
Clean with a soft/damp cloth and a minor
fingers, light deposits etc.) can be
quantity of a liquid abrasive.
removed as follows:
Spray the surface with a stainless steel
cleaner, rub in and wait several minutes
and polish with a soft, dry cloth. This last
treatment gives the stainless steel a thin
protecting coating.
To Next Page
Loading...
