EN 13 Maintenance
5.3 Cleaning the filters 5.4.1 Halogen lights | Replacing
the halogen bulbs [round]
Because of the very intensive cleaning of
the cooking vapours the filters must be
Before replacing the lights, you must
cleaned at least once a month, in case of
disconnect the appliance by taking the
an average use, preferably in the dish
plug out of the socket or by switching off
washer. Also because of food remains
the main switch.
possibly getting stuck inside the filters,
we advise not to combine the filter
Carefully insert a small screw driver under
cleaning with the usual dish wash.
the inner ring, next to one of the three lips.
The filters must be placed horizontally in
Pull the inner ring loose carefully.
the dish washer, to enable the water to
Attention: the glass part is also coming
penetrate maximally into the filter material
loose.
and also to let them dry again easily.
Remove the defective lamp.
The optional charcoal filters must be
Cut open the packaging of the new light
cleaned every 2 months in the dish
from the rear side. Attention: use halogen
washer. After 20 times they have to be
light bulbs with the same wattage. Place
replaced. The filters must be cleaned
the new light from the packaging into the
without any detergents at a high as
fitting.
possible water temperature.
Never touch the glass of the bulb with your
fingers!
Replace the ring including the glass
carefully.
One of the tabs
Optional charcoal filter
5.4.1 Halogen lights | Replacing 5.5 Maintenance of stainless steel
the halogen bulbs [square]
In the every day use, stainless steel
surfaces are being damaged and polluted.
Before replacing the lights, you must
These pollutions or damages can diminish
disconnect the appliance by taking the
the resistance against corrosion or even
plug out of the socket or by switching off
cause corrosion, depending on the nature
the main switch.
of the pollution. Pollution and damages are
not only bad to the corrosion sustainability
of the material, it will also have an effect
on the appearance of the material. Greasy
fingers, light deposits, scratches etc,
cause an neglected appearance.
Therefore, it is necessary that the
Cut open the packaging of the new light
stainless steel is given regular
from the rear side. Attention: use halogen
maintenance.
light bulbs with the same wattage. Place
the new light from the packaging into the
The stainless steel requires specific ways
fitting.
of maintenance and is based on the three
different finishes, i.e. brushed, orbital
Never touch the glass of the bulb with your
grinded and glass bead blasted.
fingers!
In case of a strong pollution and damages
a change of the surface structure can exist
by cleaning. We therefore recommend to
only have a specialist taken care of these
kind of problems. Light pollutions (greasy
fingers, light deposits etc.) can be
removed as follows:
Push the glass window at the „push“sign.
Make sure to open the window
completely.
Remove the defective light bulb.
Push to close the glass window, until you
hear a click.
EN 12 Maintenance
To Next Page
Loading...
