ABL eMH1 WALLBOX - Error Sequence F3: RCM14 or DC Fault

44
LED presets
Only green LEDs
Only blue LEDs
Both LEDs
6. ERROR MESSAGES
Sequence F3
The automatic self-test of the internal RCM14 has returned an error, or a DC fault current
has been detected in connection with the vehicle
The green and blue LEDs alternately flash twice each
200ms 200ms 200ms 200ms200ms200ms200ms200ms200ms200ms
1 If the error is occurring for the first time, the
charging procedure is interrupted for 30 seconds
and then restarted automatically. The charging
procedure is cancelled. A new charging procedure
is only possible after disconnecting the vehicle from
the Wallbox.
2 Take the Wallbox out of operation permanently.
Shutdown: p. 54
Check the vehicle for electrical faults in the
charging system. Contact a qualified specialist
repairer for this purpose.
• When error messages are displayed
continuously,
• take the Wallbox out of operation
permanently.
Shutdown: p. 54
• Contact the specialist electrical
contractor
• Should the problem persist,
please contact ABL technical support.
Technical support: p. 70