To Next PageTo Next Page
Need help?Do you have a question about the ABL Wallbox eM4 Single and is the answer not in the manual?
Details on operating the Wallbox eM4 Single after installation and configuration.
Critical warnings and general safety advice for operating the device.
Notes on regulations from grid operators, energy suppliers, and national authorities.
Information on product alterations voiding the manufacturer's warranty.
Defines intended users, supervision needs, and child safety.
Recommendations for using only ABL-approved charging cables and accessories.
Covers potential malfunctions and their causes for user resolution.
Explains different configuration modes: Controller, Extender, and Stand-alone.
Steps for authenticating charging operations using an RFID card.
Troubleshooting steps for failed RFID card verification.
Reasons and solutions for the RFID card not being recognized.
Explanation of status indicator behavior during charging interruptions.
Vehicle connected, but status indicator pulsates green; vehicle not recognized.
Status indicator pulsates red, indicating an error preventing charging.
Displays the total electrical charge consumed in kWh.
Shows active energy drawn during the current charging operation.
Identifies the charge point assigned during installation.
Displays the active charging operation time in hours, minutes, and seconds.
Shows the active power currently drawn by the vehicle.
General| Brand | ABL |
|---|---|
| Model | Wallbox eM4 Single |
| Category | Automobile Accessories |
| Language | English |
