Ref: "Ap1400ProgGuide1_2.docx" Page 19 of 42
Document Revision: “1.2”
Document Date: “9 Apr. 2013”
N.B. This value is disabled, and no splitting occurs, if bit4 of Internal Defaults (m=9) is clear.
m=42 Set EjectOffset value.
The command ESC,"X",2AH,n sets the value of EjectOffset. This parameter is used in Mark
Sense operation. See MARK SENSE OPERATION section for details.
m=48 Save all settings to Flash.
The command ESC,"X",30H forces an immediate save of all the configuration settings
to flash. This takes less than a second, but the printer goes busy during the process.
m=52 Set Auto-Save-to-Flash Period.
The command ESC,"X",34H,n1,n2 has the same format as the (m=11) command. By default
the Auto-Save-to-Flash function is disabled (See below for more details).
m=66 Set Print Darkness.
The command ESC,"X",42H,n sets the value of print darkness. This value controls the
operation of the printing process to suit different paper types.
Valid values are in the range 55H to 90H. Increasing the value causes the printed output to
become darker. 55H suits standard thermal paper. 90H suits Linerless paper.
Saving Configuration Information
All configuration information must be saved to Flash if it is to be non-volatile. Ideally, this should be
performed manually by sending the command ESC,"X",30H (see above).
Alternatively, the printer maintains a special timer which will perform an automatic save of the
configuration information after a pre-set period of inactivity. This automatic timed save is normally
disabled, but may be enabled by sending the ESC,"X",34H,n1,n2 command.
Note that during the saving procedure the printer effectively performs a full system reset. Therefore, it
is advised that the save command be issued in isolation (i.e. not embedded in a stream of printable
data).
To Next Page
Loading...
