NX Series Product User Manual
2. Align the positioning column of the first-layer cabinet with the positioning
hole of the hanging beam, and use M8*40mm screws to lock the cabinet and
the hanging beam. Use M8*40mm screws to connect and lock between the left
and right adjacent cabinets. When installing, pay attention to check the flatness
of the left and right cabinets, and lock and fix after confirming that they are flat;
Note: Use connecting blocks to install between large and small cabinets.
Mounting screw: cylindrical inner hexagon full thread machine screw M6*60mm
3. Install the cabinets of the second layer in sequence according to the above
operation methods, and use screws to lock the adjacent cabinets. When
installing, pay attention to check the flatness between the top and bottom and
left and right of the cabinet, and lock and fix after confirming that it is flat;
4. Repeat the above steps to complete the installation of all cabinet frames;
To Next Page
Loading...
