Absima CR4S - Safety Precautions; Understanding Safety Symbols; General Safety Guidelines

1
• Misuse of this product may lead to serious injury or death. To ensure the safety of you
and
your equipment, read this manual and follow the instructions.
• Make sure the product is properly installed in your model. Failure to do so may r
esult in
serious inju
ry.
•
to do so may lead to unintended operation and cause an accident.
•
•
• Do not use the product at night or in bad weather like rain or thunderstorm. It can
cause er
ratic operation or loss of control.
• Do not use the product when visibility is limit
ed.
• Do not use the product on rain or snow days. Any exposure to moisture (water or snow)
may
cause erratic operation or loss of control.
• Interference may cause loss of control. To ensure the safety of you and others, do no
t
operate in the following places:
• Near any site where other radio control activity may occur
• Near power lines or communication broadcasting antennas
• Near people or roads
• On any body of water when passenger boats are present
•
alcohol or drugs. Doing so may cause serious injury to yourself or others.
• The 2.4GHz radio band is limited to line of sight. Always keep y
our model in sight as a
la
rge object can block the RF signal and lead to loss of control.
• Do not touch any part of the model that may generate heat during opera
tion, or
immedi
ately after use. The engine, motor or speed control, may be very hot and c
an
cause serious burns.
Prohibited
Mandatory
1.Safety
1.1 Safety Symbols
Pay close attention to the following symbols and their meanings. Failure to follow these warnings could cause damage,
injury or death.
1.2 Safety Guide
Warning • Not following these instructions may lead to major injuries.
Danger • Not following these instructions may lead to serious injuries or death.
Attention • Not following these instructions may lead to minor injuries.
Do not use this product when you are tired, uncomfortable, or under the influence of
Make sure to disconnect the reveiver battery before turning off the transmitter. Failure
Ensure that all motors operate in the correct direction. If not, adjust the direc
tion
fi
rst.
Make sure the model stays within the systems maximum range to prevent lo
ss of
c
ontrol.