User Level
Username:
Passw ord:
Usernam e:
Password:
Ad ministrator Level
user
user
ad m in
ad m in
IR, RS232 A ND TELNET OPERATION
W EB INTERFACE OPERATION
UM matrix switchers can also be controlled via IR, RS232 or Telnet. Please refer to the speci c documentation, available at
www.absoluteacoustics.com for a complete description of the control functions and codes available for each protocol.
Control via integrated Web Interface is a friendly option for most users. To access it, follow the instructions in the next section of this
document.
Web Interface
UM matrix switchers provide a Web Interface for device control and con guration. To access the Web Interface, rst connect the device
in an Ethernet network. Then, enter the current IP address in a web browser.
When you start the Web Interface access, you'll be prompted to insert the credentials. Two access levels are available: at User level,
only device's operational controls are available; at Administrator level, operational controls and device con guration options are
available. The default credentials are listed below:
Note: The device's default IP settings de ne the addressing mode as DHCP. To nd the address associated with the device, use a
network scanner software. The unit will show up in the scanner as ”Absolute”.
Note: The Web Interface access passwords can be changed by the system administrator. If you cannot login, you must restore the
device's factory settings.
In case a network scanner is not available, the current IP address can be found on the matrix switcher’s display.
Press and hold the rightmost button and navigate between the status screens with the and keys until the current IP address
shows up.
NDS-UM
To Next Page
Loading...
Need help?
General