Installation and start-up
EN 17
Displays and functions
Teach-in process
1. Set the Secvest to "teach-in mode" (see installation instructions for wireless
alarm system) and send a teach-in signal from the wireless control panel to the
wireless alarm system.
2. The teach-in signal can be sent either by inserting the batteries or by activating
the tamper switch.
3. Once the teach-in signal has been picked up by the wireless alarm system, it
will emit two beeps and the incoming signal strength will be displayed.
4. Confirm the successfully completed teach-in on the control panel.
operation
You can cancel incorrect code entries by pressing the star key
(see adjacent figure).
If the user code is entered incorrectly three times, the control panel
keypad will flash and will be locked for 5 minutes.
To Next Page
Loading...
Need help?
General
