22
Connect multiple adapters
If you have problems connecting multiple adapters, please try as follows:
Reset all adapters to factory settings.
Plug all adapters together into a multiple socket.
Press the pairing button (SECURITY for 2-3 sec.) immediately after each other.
After a short wait two adapters will connect.
It can take up to 1 to 2 minutes for the third adapter to connect.
If the Powerline LED on the third adapter stops flashing and goes off without any
connection, continue with the following steps:
Press the pairing button again at the first adapter of the already paired ones, after
that press the paring button at the third adapter again.
If this does not succeed again, the third adapter may be defective.
Please check if a simple pairing with only two adapters is possible to identify the
defective adapter.
WARNING
Disconnect the Powerline adapter from the power source before servicing
For indoor user only
Do NOT open the casing
Do NOT use near water
Do NOT insert sharp objects into the adapter’s socket
Socket maximum output is 15A (ITAC10300)
To Next Page
Loading...
