– 28 –
e) The adhesive bond will reach its
2. Drilled hole mounting
Application:
a) Using an 8-mm drill bit, drill a
hole at the installation position
(take care not to strike any electric
b) Insert the 8-mm dowel into the
c) Push the supplied 5-mm counter-
sunk screw through the bottom of
the magnetic holder and into the
d) Tighten the screw into the dowel
so that the screw sits flush and is
fully sunk into the recess provided
e) Only tighten the screw enough to
prevent the magnetic holder from
f) Place the device on the magnetic
ved from the magnetic holder by
pulling it gently in a vertical
GENERAL SAFETY GUIDELINES
Smoke alarms are designed to help
they cannot extinguish a fire nor pre-
vent it starting, nor can they notify
ted by the presence of combustion
gases, smoke alarms emit a loud alarm
Despite great care in the manufacture
of smoke alarms, it is also possible
that a fault may occur that prevents
the device from warning of a potential
fire, or from doing so in good time!
The usual precautions in relation to
fire, flammable materials and techni-
ved! Please do not expose the device
to direct sunlight or extreme heat,
because it could damage the built-in
MoAnltg RWM 250_DE_GB_FR_NL_IT_2015_NEU.indd 28 16.07.15 10:12
To Next Page
Loading...
