Abus TVVR36301 - Page 65

23
In the event of an alarm, the unit can send a message by email. Enter the email
configuration here.
Server
authentication
Activate the checkbox if authentication on the server should/is
necessary.
Username
Enter the username of your e-mail account here
Password
Enter the password from your e-mail account here
Sender
Enter the sender name here
Sender address
Enter the e-mail address belonging to the e-mail account
here.
Select recipient
Here you can select up to 3 different recipients and then enter
their e-mail addresses.
Receiver
Enter the name of the recipient here
Recipient address
Enter the e-mail address of the recipient here
Attach picture
Activate the checkbox if, in addition to the e-mail, recordings
from the camera are to be sent as photo files.
Interval
Select a trigger time between 2 and 5 seconds here. The
images are only sent when movement has been detected
over the defined period.
SMTP Server
Enter the SMTP server address of the e-mail provider here.
SMTP Port
Enter the SMTP port of the e-mail provider here.
Enable SSL/TLS
Activate 'Checkbox' to enable email encryption