AC Infinity CLOUDFORGE - PROGRAMMING AND MODES; CONTROLLER INTERFACE AND MODES

24
PROGRAMMING
3. SETTING BUTTON
Cycles through the controller’s
settings: °F / °C, CALIB. T° /
H% / kPa, and LEAF OFFSET.
1. MODE BUTTON
Cycles through the controller’s
modes: OFF, ON, AUTO (1
trigger), VPD (1 trigger), TIMER
(to OFF), CYCLE (ON and OFF).
4. PROBE TEMPERATURE
Displays the current temperature
that the probe is measuring. Shows
"--" if no probe is plugged in.
6. PROBE VPD
Displays the current VPD that
the probe is measuring. Shows
"--" if no probe is plugged in.
7. CURRENT MODE
Displays the controller's current
mode. Pressing the mode button
cycles through the available modes.
2. UP/DOWN BUTTONS
Adjusts the value of your current
mode. The up button increases
and down button decreases
the setting. Hold both to reset
values to OFF/Default.
5. PROBE HUMIDITY
Displays the current humidity that
the probe is measuring. Shows
"--" if no probe is plugged in.
8. CURRENT LEVEL
Displays your humidifier's current
moisture level.
11. ALERT ICONS
Displays alerts and statuses of
the onboard controller, including
the controller lock, CLIMATE
alert, and TIMER alert.
10. USER SETTING
Displays the value of your current
mode. Use the up or down
buttons to adjust the value.
9. COUNTDOWN
Displays the countdown of the
TIMER or CYCLE modes that
activates or deactivates your
humidifier. TO ON shows the
amount of time left before your
humidifier turns on. TO OFF
shows the amount of time left
before your humidifier turns off.
1
2 3
4
6
8
9
10
11
5
7
Screen shown: CLOUDFORGE T3