32
PROGRAMMING
CALIBRATION HUMIDITY SETTING
Adjusts the relative humidity reading the sensor
probe is measuring. Press the up or down
button to increase or decrease the data figure
in 1% increments. The calibration cycle ranges
from -10% to 10% and will be applied to the
sensor probe’s measurements.
CALIBRATION LEAF OFFSET SETTING
Adjusts the VPD reading the sensor probe
is measuring. Press the up or down button
to increase or decrease the data figure in 1°
increments. The calibration cycle ranges from
-20°F to 20°F (or -10°C to 10°C) and will be
applied to the sensor probe’s measurements.
Screen shown: CLOUDFORGE T3
Screen shown: CLOUDFORGE T3
To Next Page
Loading...
