35
Q:
A:
Why does my screen turn off when I connect my heater to a UIS controller?
A UIS controller will override your heater's onboard programming. Your device's screen will shut
off and you can program your device directly through the smart controller.
FAQ
When I connect to a smart controller, which sensor probe is active?
The sensor probe plugged into your controller will override the heater's sensor.
Q:
A:
How should I route my heater's ducting?
Set your heater outside of your grow tent and channel the ducting through one of its lower
duct ports.
Q:
A:
Can I place this heater inside of my grow tent?
You may place your heater inside of your grow tent as long as its humidity level does not rise
above 65%. Otherwise we recommend keeping your heater outside of your grow tent and
directing heat from it using the built-in ducting with duct extension (as needed). See above.
Q:
A:
To Next Page
Loading...