Acard ARS-2021 - Page 15

To Next Page

To Previous Page

ARS-2021/2021S Copy Smart Plus

Step 2: Screw up the hard disk with metal frame on the rack.

Step 3: Connect the 44-pin cable to hard disk.

Main Page

Default Chapter3
- Table of Contents3
Chapter 1 Introduction5
Overview5
Features5
Specifications6
Chapter 2 Installation Procedure7
Whole Duplicator Without Writer Installed7
Completed Duplication System7
Preparing for Installation8
Installation of CD-R/RW Drive9
Installation of CD-ROM Drive11
- Installation of 2.5" Hard Disk14
Installation of Copy Smart Plus Cabinet16
Chapter 3 Key Functions and Operating Instruction18
Chapter 4 Board Layout21
Chapter 5 Copy Smart Plus as Hosted CD Drives22
Connect Copy Plus (ARS-2021S) to Host Computer22
Configuring Copy Smart Plus22
Hardware Requirement22
Software Requirement22
Copy Smart Plus DIP Switch Adjustment23
Chapter 6 Function24
Copy24
Test24
Test&Copy25
Verify26
Compare26
Prescan27
Disc Info28
Select Source28
Image29
- Load29
- Delete Image30
- Image Info30
- Compare Image31
- Select Partition32
- Select Image32
- Select Src Drive33
Edit Track33
- CD to CD Edit33
- Image Src Drive33
- Edit Track35
- CD to HD35
- Play Audio Track38
- Close Session39
Setup39
- Language (Optional)40
- Burn Speed40
- Read Speed40
- Auto Start Drive41
- Startup Menu41
- Auto Verify41
- Auto Compare42
- Auto Prescan42
- Eject Disc43
- Burn on the Fly43
- Burn Mode44
- Button Sound44
- Device Info45
- System Info46
- Quick Erase46
- Full Erase47
Adv Setup47
- Underrun Protect47
- Overburn48
- Read Error Skip48
- Format Hard Disk48
- Verify HDD49
- Burn-In49
- Format Hdd49
- Update Firmware50
- Compare Firmware51
- H/W Diagnostic51
- Load Default52
Chapter 7 Troubleshooting53
Appendix 1 Optional SCSI-IDE Bridge Products55
Appendix 2 LCD Message List56
Appendix 3 Technical Support Form59

Acard ARS-2021 - Page 15

Table of Contents