Page 9
START-UP PR OCEDURE
Once the spa is delivered and the electrical installation accomplished, the next
step is to fill it and heat the water.
IMPORTANT
It is recommended to perform the following procedure when you
drain and refill the spa, to protect the heater element.
• Power must be turned OFF at the circuit breaker and at the G.F.C.I before you start.
• Open the access door and inspect all fittings to be tight and slide-valves fully extended.
• Fill the spa, using your garden-hose, to the proper water level (half way mark on
the skimmer door).
• To apply power, push the RESET (ON) button at the G.F.C.I. & reset Circuit Breaker
to the ON position.
• Press the Jets button at the Spa Side Control Panel activating the high speed
pump. Keep pump running for at least three minutes to purge the air out.
• Once air bubbles stop coming out of the jets and the pump is primed select the
desired temperature.
IMPORTANT: TURN DOWN THE HEAT BEFORE YOU DRAIN AND REFILL
YOUR SPA TO PROTECT THE HEATER.
The filter cartridge(s) must be cleaned periodically. It should be totally
submerged. If the top of the cartridge is above water level, air is sucked into the
pump's intake causing pump surges, lower pressure and damage to the heater.
FILTER CARTRIDGE S
To Next Page
Loading...
